1st Generation Bracket

1st Generation Bracket For use with flex transducer arm over side of kayak

1st Generation Bracket For use with flex transducer arm over side of kayak

1st Generation Bracket For use with flex transducer arm over side of kayak

1st Generation Bracket For use with flex transducer arm over side of kayak

1st Generation Bracket For use with flex transducer arm over side of kayak

1st Generation Bracket For use with flex transducer arm over side of kayak

1st Generation Bracket For use with flex transducer arm over side of kayak

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. Transducer and aluminum plate fit in the Frontier Tracking Channel. It should be noted the Tracking Channels are a tiny bit wider at the front of the kayak and slightly taper towards the rear of the kayak. The current position of the TotalScan Transducer is in a location where it sits flat on the Tracking Channel.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. Transducer and aluminum plate fit in the Frontier Tracking Channel. It should be noted the Tracking Channels are a tiny bit wider at the front of the kayak and slightly taper towards the rear of the kayak. The current position of the TotalScan Transducer is in a location where it sits flat on the Tracking Channel.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. Transducer and aluminum plate fit in the Frontier Tracking Channel. It should be noted the Tracking Channels are a tiny bit wider at the front of the kayak and slightly taper towards the rear of the kayak. The current position of the TotalScan Transducer is in a location where it sits flat on the Tracking Channel. I am running the transducer wiring through the scupper hole.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. I have added zip-tie anchors along the Tracking Channel to hold the transducer cable. The zip-tie anchors are affixed to the kayak with short flat head sheet metal screws and I put a liberal amount of GOOP marine sealer between the kayak and anchor.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. I have added zip-tie anchors along the Tracking Channel to hold the transducer cable. The zip-tie anchors are affixed to the kayak with short flat head sheet metal screws and I put a liberal amount of GOOP marine sealer between the kayak and anchor.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. I have added zip-tie anchors along the Tracking Channel to hold the transducer cable. The zip-tie anchors are affixed to the kayak with short flat head sheet metal screws and I put a liberal amount of GOOP marine sealer between the kayak and anchor.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. I have added zip-tie anchors along the Tracking Channel to hold the transducer cable. The zip-tie anchors are affixed to the kayak with short flat head sheet metal screws and I put a liberal amount of GOOP marine sealer between the kayak and anchor.

2nd Generation transducer mount. Using an aluminum plate and 3-M Dual-Lock fastening system. This image show the clearance between the transducer and the bottom of the kayak.

Rubber stopper which has been drilled and cut to accommodate transducer cable.

Rubber stopper which has been drilled and cut to accommodate transducer cable.

Rubber stopper which has been drilled and cut to accommodate transducer cable.